Description
Frame Loop 25mm with kick
If you are looking for a way to clean up the rear end of your Cafe racer, Bobber or Tracker check out these frame loops. Made from 1 inch (25.4mm) tubing with a wall thickness of 1/16th inch (1.7mm) these will match many aftermarket seat bases or you can make your own seat base. Standard diameter bend is 9 inch (230mm) to the outside of tubing.
We are the only workshop offering a pre made kick-up tail loop. We can do the bend 110mm or more from the end of the loop. The maximum we can bend the kick-up is 7 degrees due to over distortion of the pipe. At 110mm and 7 degrees the rise at the end is approximately 40mm. If you require more we suggest you look at one of our standard loops and either a) heat and bend or b) cut and re weld the required kickup.
Annie Belle –
Annie Belle liked this on Facebook.
Brad Mccormack –
Brad Mccormack liked this on Facebook.
Glenn Riley –
Glenn Riley liked this on Facebook.